Page 10 - BENK YAPI - Construction Chemicals
P. 10
GRANITE AND MARBLE ADHESIVE
PRODUCT DESCRIPTION
It is a cement-based, ceramic, granite ceramic, granite, marble, natural
stone, porcelain, large-size coating material adhesive mortar with high
adhesion strength, reduced slip, extended working time.
USAGE AREAS
Benkim granite marble adhesive; It is used for sticking ceramic etc.
coating materials with low water absorption rate on old ceramic coated
surfaces, indoor and outdoor horizontal and vertical surfaces.
It is used in places exposed to heavy traffic indoors and outdoors, and
on the floors and walls of places where temperature changes are too
much. Wasserdamm elastic is used for bonding coating materials on
Wasserdamm fully elastic surfaces and for bonding ceramics on
ceramics with Baumix primer applied.
PRODUCT ADVANTAGES
• It is used for bonding large sized veneers.
• Thanks to its polymer additive, it provides high elasticity and adhesion strength.
• It is water and frost resistant.
• As the open waiting time is extended, it increases the working time.
• It is easy to prepare and apply.
• It does not slip in vertical applications.
PERFORMANCE
Initial tensile bond strength ш ϭ Eͬŵŵϸ d^ E ϭϯϰϴ
Tensile adhesion strength after immersion in water ш ϭ Eͬŵŵϸ d^ E ϭϯϰϴ
Tensile adhesion strength after heat aging ш ϭ Eͬŵŵϸ d^ E ϭϯϰϴ
Tensile bond strength after freeze-thaw cycle ш ϭ Eͬŵŵϸ d^ E ϭϯϰϴ
Tensile adhesion strength after open time (after 30 min.) ш Ϭ͕ϱ Eͬŵŵϸ d^ E ϭϯϰϲ
Slip ч Ϭ͕ϱ ŵŵ d^ E ϭϯϬϴ
Fire reaction class ϭ d^ E ϭϯϱϬϭ Ͳ ϭ
These values are in laboratory conditions; It was obtained as a result of experiments carried out in 23 ± 2°C and 50% ± 5%
relative humidity environment. The values given in the table may differ depending on the surface and ambient conditions.
REFERENCE STANDARDS
Approvals/Standards
d^ E ϭϮϬϬϰ
Surface Preparation
• The surface must be dry, clean, sound and free from dust, oil, dirt or adhesion blocking.
• materials should be cleaned from the surface, materials such as mortar and cement residues should be scraped.
• The dusty surface behind the ceramic should be moistened and cleaned.
• Repair of surface defects with a depth of more than 1 cm, repair 24 hours before application
should be done. Depending on the condition of the surface, Ergonomix Mortar or Baumix repair mortar should be used.
• After surface cleaning, the surface should be primed with Baumix primer as a single layer in order to increase the
adhesion strength and balance the surface absorbency and leave to dry for 1-2 hours.
• Before starting the application on brut concrete surfaces, the surface should be primed with Baumix brut concrete
primer as a single layer and left to dry for a minimum of 8 hours in order to increase the adhesion strength.
10